Problem solutions
Carbon4 is the perfect problem solver
Carbon4 can be installed easily and with very little effort in areas with rising damp, cold bridges and mold.
As there are also no restrictions in terms of geometry, Carbon4 can also be applied to uneven walls without any problems.
Carbon4 is often the only solution for listed buildings in particular, as the existing masonry is not altered and no conversion work is necessary.
For walls with a particularly high salt content, we have specially coated copper strips that can withstand the salt.
The heating coat is open to diffusion and moisture can escape without any problems.
Facts & Info
For drying, we place a heating strip of 40 to 60 cm – depending on the area of application – just above the floor on the wall and leave the heating on for the first few days. The heat penetrates deeply and removes the moisture from the masonry. In this first phase, it is always important to use a professional drying device to collect the moisture in the room.
As soon as the masonry is almost dry, the built-in wall sensor is activated and the heating system only cycles and keeps the temperature constant. This allows walls to be kept permanently dry and saves very expensive external conversion work. Carbon4 provides a cost-effective and uncomplicated solution to the problem, without major conversion work.
Energy consumption is also very low, as the system only has a minimal running time after the first drying phase.
