Skip to content
Consultation Partner

CARBON4® Complete. Insulating and heating in one.

The heating paint as a prefabricated system board: copper strips, mesh, heating paint and filler sit on a flame-retardant wood fibre insulation board – fully assembled and tested.

Build-up

Seven components. One board.

Complete arrives on site fully assembled with six components. The final fine filler coat is applied on site by the painter or drywall installer – fully reinforced.

Build-up of CARBON4® Complete in seven components: wood fibre insulation board, fine filler, adhesive tape and copper strip, glass-fibre mesh, heating paint, fine filler with mesh, fine filler on site
Components

From insulation board to surface

  1. Wood fibre insulation board, flame-retardant
  2. Fine filler
  3. Double-sided adhesive tape + copper strip
  4. Glass-fibre mesh
  5. CARBON4® heating paint
  6. Fine filler + full-surface mesh
  7. Fine filler – applied on site by the painter or drywall installer, fully reinforced

Source: CARBON4® Complete data sheet, as of 01/2026.

Technical data

At a glance

Board size1,810 × 610 × 20 mm
Output per boardapprox. 300 W
Surface temperature45–55 °C
Operating voltageLow voltage, preferably 24 V
Reaction to fireC-s1, d0
sd value0.08 m (vapour-permeable)
ApplicationWalls and ceilings
Diagram of a wall made of heated Complete and unheated Pure boards
Complete + Pure

Heated where it counts. Flat everywhere.

Complete boards are heated. CARBON4® Pure is the unheated counterpart with the same thickness and surface. Pure fills remaining areas, junctions and zones without heating – creating a continuously flat wall or ceiling.

  • Rule of thumb: 1 Complete board to 3 Pure boards
  • No more than 3 Complete boards in a row
  • Only Pure boards may be cut to size
  • Board layout planned by CARBON4®
Application

Where Complete plays to its strengths.

Wall

Insulate and heat

Interior insulation and wall heating in one step – ideal for external walls in existing buildings.

Ceiling

On concrete or hollow-core ceilings

Mounted directly, without a complex substructure.

Damp

After drying out

Damp protection and full heating when the wall should also heat after remediation.

Not for floors

Too soft for floor loads

On floors we use the heating paint directly – more on floor heating.

What is the difference between Complete and Pure?
Complete boards are heated. Pure boards have the same thickness and surface but no heating layer. They fill remaining areas, junctions and zones that are not to be heated – creating a continuously flat surface. Only Pure boards may be cut to size.
Where is CARBON4® Complete used?
On walls and ceilings – in new builds, renovations, existing and listed buildings, also directly on concrete or hollow-core ceilings. Complete makes particular sense when a wall is to be insulated and heated, for example after damp remediation.
Can Complete be laid on floors?
No. The wood fibre insulation board is too soft for floor loads. On floors, the heating paint is applied directly to screed or dry-construction boards.
How is the surface finished?
The boards are factory-finished with fine filler and full-surface mesh. After installation the joints are closed; paint or plaster then follows as specified by CARBON4®.

Your project. Individually planned.

Initial consultation of 30–45 minutes, by phone or video call.

Request a consultation →Call